Forums >> Revit Building >> Technical Support >> using array on wall reveals - 2008

architurk

active

Joined: Mon, Oct 9, 2006
58 Posts

i use 2008 version

i needed reveals on a L shaped thick wall

1- i tried to do it within wall type edit, but at first adding reveals there didnt seem practical to me (i have expected sth like array, or ability to give distance from the previous reveal: because the position of there reveals might change afterwards) and also it didnt look fine at endings of my "edited profile" wall openings.

2- i tried to make it host sweep/wall reveal. i make the reveal turn the corner (by adding another reveal at the same level or by extending reveal till the edge and changing sweep returns) but when i apply array (i found out that array might be applied only on section view?!?)  on this L shaped reveal it only multiplies one segment.

what do i do wrong?

thx for ur timesaving helps!!! 

This user is offline

KingRevit

active

Joined: Mon, Oct 15, 2007
321 Posts

easiest way i find for arraying wall reveals is to place in your reveals.

select your one of your reveals in an elevation view

use isolate catagory. even though you can see them you can still select them drag a box to select all the reveals you want then use the array tool.

This user is offline

architurk

active

Joined: Mon, Oct 9, 2006
58 Posts

i am sorry but it seems i couldnt expose my question clearly, so please take a look at attached rvt file. there i have a wall reveal component and THERE IS NO WAY I CAN NEITHER COPY NOR ARRAY that reveal.

any quick reply would be greatly appreciated

thx

This user is offline

KingRevit

active

Joined: Mon, Oct 15, 2007
321 Posts

delete your window then array your reveal then put the windows back in.

or place in new reveals at the requires location.

This user is offline

Wall Reveals

3

Precast panels and vertical reveals

8

Wall Reveals

1

Reveals and Voids

0

Vertical wall reveals

0