Forums >> Revit Building >> Technical Support >> create a wall sweep on an angled wall (gable end wall) (2017)

ledgewood33

active

Joined: Wed, Jan 27, 2010
34 Posts

I was wondering how to create a wall sweep on a gable-end wall? I would like to show a trim board at the top of the gable-end wall that follows the angle at the top of the wall. when I try to use the wall sweep tool it seems to only let me move in the vertical or horizontal direction.

This user is offline

WWHub

site moderator|||

Joined: Tue, May 16, 2006
13079 Posts

Wall sweeps are either vertical or horizontal - nothing else.   An in-place sweep will work but it will not be correct at the corners.

This user is offline

ledgewood33

active

Joined: Wed, Jan 27, 2010
34 Posts

so at the corners can I use a void form to cut the portion of the sweep that I dont want to see? if so what would be the best void form to use in this situation?

This user is offline

WWHub

site moderator|||

Joined: Tue, May 16, 2006
13079 Posts

Does it matter?  Any void you create (in-place) will work becuse you will set it to cut your sweep and will not cut anything else.

BTW - Not saying this is a good solution but a thin wall sketched to the same you need will also work as well as an in-place extrusion sketch to the shape.  

This user is offline

Bartholomew

active

Joined: Mon, Aug 6, 2012
0 Posts

you could use use a roof fascia with a negative horizontal profile offset the distance of the overhang. Just a thought. 

This user is offline

Angled Wall Sweep End

4

Gable End Wall

1

Newbie: Attach wall to roof gable end: Strange Rendering

4

REVIT 2013 - Angled Layered Wall Ends

3

Could not create integral wall sweep for wall instance......

2