Forums >> Revit Building >> Technical Support >> Topography Building Relationship Issues

C11515907

active

Joined: Thu, Apr 18, 2013
0 Posts
No Rating

Hi All

I have been working on quite a large project lately and when creating each building on the site I set them to there actual levels and used shared Datum levels. This was all working fine until I tried to Import the site. I used a AutoCad file and created a toposurface from import. When this site was generated it was placed above the buildings. For example one of the buildings is 127000mm above seal level and it is currently set to that level but the site is then 127000mm above that building. I moved the site down 127000mm using the move command but ofcourse all the surface points are now incorrect(1270000 less than what they should be).

Could anybody tell me how to make it so the site and buildings are both on a shared datum?Any help would be much appreciated. Adam

This user is offline

WWHub

site moderator|||

Joined: Tue, May 16, 2006
13079 Posts

Watch this video. 

http://www.youtube.com/watch?v=BigvY4LT-RI

This user is offline

C11515907

active

Joined: Thu, Apr 18, 2013
0 Posts
No Rating

Brilliant video thank ou very much. I have moved my project to 127000mm, so should I bring that back to 0 and start from there? 

This user is offline

Topography and Building relationship

8

Issues with Topography

4

Building Pad Altering My Topography Surface

2

Topography Issues

1

New to using Topography & Building Pads

7