Forums >> General Discussion >> Revit Project Management >> scheduling door finishes and materials

lpluger21

active

Joined: Wed, Nov 4, 2009
0 Posts
No Rating

Hi Everyone,

I am recreating my offices door and window schedule in revit 2015 and I am just about there but I am having an issue with scheduling the finishes. The frame material is a pre determined field in revit so that was easy. Our doors and frames are always the same material so I made a calculated value for that no problem. But where I run into an issue is getting independent interior and exterior door finishes. I am fine with having to enter the information manually in the schedule, but I can't figure it out. I have attached our CAD version so you can see what I am going for and also what I have so far. Any suggestions would be helpful. Thank you!

Attached Images

This user is offline

WWHub

site moderator|||

Joined: Tue, May 16, 2006
13079 Posts

You can add shared parameters to your project (AND TEMPLATE) for this data or it can simply be an added schedule parameter.

This user is offline

lpluger21

active

Joined: Wed, Nov 4, 2009
0 Posts
No Rating

Thank you! I got it working with your solution.

This user is offline

How to Hide Door Transition Strip with Materials Finishes in RCP (Revit 09)

1

Door parameters not scheduling or tagging in double door.

5

Finishes schedule with materials spec in it

1

Door Finishes - Scheduling & Rendering

0

Materials vs Finishes question - where does information go?

6