Forums >> Revit Systems >> Technical Support >> fabmep to revit

vinnygolfer

active

Joined: Wed, Jul 8, 2009
181 Posts

hi all, i'm using Revit 2015 and my piping designers are using Autocad 2015 with FabMEP add on. i have a project that is requiring Revit deliverable. when i tried to import the .dwg file i got an error, "some acis objects could not be imported. to import them, use autocad to convert them into polymesh objects and re-import". i have tried to figure out how to do that in autocad, with no luck. i have exported the file as a .ifc, and then tried loading that into the Revit project with no luck. i have seen some posts on-line and none of them really give a way to do it, they just state that it's a problem. i have a week to get this done, but i'm trying to get out in front of this.

thank you

-----------------------------------

Try to learn at least one new thing every day

This user is offline

WWHub

site moderator|||

Joined: Tue, May 16, 2006
13079 Posts

See if this helps: http://www.revitcity.com/forums.php?action=viewthread&thread_id=17023

This user is offline

vinnygolfer

active

Joined: Wed, Jul 8, 2009
181 Posts

i have seen that before when i was searching. i don't know how to use that. i'm not a programmer, and have know idea where to even start with that list. i follow directions well, but don't know where to start with this.

-----------------------------------

Try to learn at least one new thing every day

This user is offline

Autocad FABmep 2013 Network License

0

Specialist Fabrication company - deciding whether or not to adopt Revit?!

3

Revit for Construction Documents [ 1 2 ]

20

4D simulation in Revit? [ 1 2 ]

18

I need to open a Revit 2011 file into the Revit 2009 ? Are there any way ? [ 1 2 ]

18