Forums >> Revit Building >> Technical Support >> Stacked Walls - how to set wall core

Jamie351

active

Joined: Mon, May 23, 2011
124 Posts

Hey guys Im having trouble with stacked walls and my roof.

I cant seem to set the wall core and it is not using either one of the two walls selected. 

My roof needs to be extended to wall core so the truss pitches of the stud wall. 

Attached Images

-----------------------------------

Revit 2018........

This user is offline

Beaucoupnice

active

Joined: Mon, Nov 19, 2007
93 Posts

To control wall layers in section details, you need to use View - graphics section - cut profile. This is view only change and does not change it in 3D. If you want to change it in 3D you can create in place family made of a void and make it cut the wall out as you need.

To be frank I have never cut out walls in 3D only as it would be detail overkill. Using cut profile will be fine.

-----------------------------------

__________I'm the guy they come to when they didn't follow my recommended workflows.__________

This user is offline

WWHub

site moderator|||

Joined: Tue, May 16, 2006
13079 Posts

If you want a model solution, you need to modify that wall's definition to unlock one of the layers to either pull it down or up.  But to adjust that in the model, you will have to unstack the wall.

This user is offline

Stacked Wall Core

1

Dimension Stacked Walls

2

Stacked walls on irregular levels

1

Stacked wall joins, floor cut geometry, etc..

0

Scheduling of Stacked Walls

0