Forums >> Revit Building >> Technical Support >> Horiz mullions wont clean up because of angled corner mullion

SharperMarbles

active

Joined: Wed, Mar 10, 2010
0 Posts
No Rating

Please see my attached pic. I've created a butt glazed corner mullion sim to a Kawneer extrusion. My profile actually shows it at this angle. But you can see what it does to my horizontal mullions. I hope you can see my intent from the graphic. What's the best way to make this clean up. I've also uploaded the corner mullion family so you can tell me if I'm doing it all wrong. In my model I had to make my two CWs not join at the corner, because otherwise it wouldn't allow me to get the corner mullion all the way in the corner.

Any help is really appreciated!

Attached Images

Attached Files 134630_2.5_x_4_in_back_corner_butt_glaze.rfa

This user is offline

cleanup horizontal mullion at corner mullions, again....

7

Problem with Curtain wall Mullion clean up at corners

3

Mullions at corner of curtain walls

1

connecting horizontal mullions around a corner mullion

3

Adding New Mullions to your Mullion Tab Options

6