Forums >> Revit Building >> Technical Support >> Split Faces & Decals

ahelman

active

Joined: Fri, Jan 22, 2010
0 Posts
No Rating

I have a wall with two paint colors and a piece of artwork as the dividing line.  I used Split Face to divide the wall and the Paint tool to apply the color to each side of the line.  Everything rendered beautifully (image 1).  I  then continued to add the Decal to the wall face.  Everything looks great in the model (image2), but when I went to render it's as if the split face was ignored and only one of the two colors at random were rendered on the entire wall (image 3).  Any suggenstions on this matter would be greatly appreciated.  Thank you.

Attached Images

This user is offline

WWHub

site moderator|||

Joined: Tue, May 16, 2006
13079 Posts

Could this be your transparecy settings for the image?

I've never done an image that was not a full rectangle so I need to experiment with this.  Were the non-image areas set to transparent in your jpg? 

Does this image have a bump patterN?

This user is offline

Modifying Slab deletes split faces

4

Decals not rendering

8

Can't split certain faces

6

Split Faces

0

split face tool on curved extrusion

13