Forums >> Revit Building >> Technical Support >> Filters

Joetaba

active

Joined: Wed, Apr 15, 2009
17 Posts
No Rating

After using the create parts button to a wall Is there a way to apply a filter to just parts of a wall? As far as I can tell the filter will only filter parameters associated with the entire wall. Didn't know if I was overlooking something. Thanks.

I'm using Revit 2014 

This user is offline

Existing Filters into a Callout

2

Lineweights For System Filters

5

Heating filters

1

Filters in visibility graphics

1

Advice on a touchy graphics issue - lots of filters or a mix of varied ways

2