Forums >> Revit Building >> Technical Support >> Vertical Fascia on Roof by Extrusion - Is it possible?

PBWC

active

Joined: Wed, Mar 21, 2012
0 Posts
No Rating

Hi all

Have created a vertical element of roofing which curves down over an external wall. I want to create a continuous element of fascia, however, fascia can only be applied to the piece of roof created using 'Roof by Footprint' and will not automatically snap to the vertical element of roof.

Any ideas?

Using Autodesk Revit 2014

Thanks

Lee

This user is offline

View Website

teafoe5

site moderator|||

Joined: Fri, Nov 12, 2010
1749 Posts

A roof cannot be totally vertical.  Can you attach an image of what you are trying to do?

This user is offline

View Website

PBWC

active

Joined: Wed, Mar 21, 2012
0 Posts
No Rating

Thanks for the reply.

My roof is totally vertical created by using Roof by Extrusion tool..

I have overcome this I think by using an in-place family and a sweep to create my profile for the length of the vertical section.

I'll post up a image later.

Thanks

Lee

This user is offline

View Website

PBWC

active

Joined: Wed, Mar 21, 2012
0 Posts
No Rating

See image attached.

Thanks

Lee

Attached Images

This user is offline

View Website

ARCHED ROOF FASCIA

2

arched roof edge

2

How to miter a fascia on a sloped roof?

1

Roof fascia curves in plan and elevation

9

Roof Fascia On Negative Sloped Roof

4