Forums >> Revit Building >> Technical Support >> surface pattern visibility
|
|
active
Joined: Wed, Jan 27, 2010
34 Posts
 |
I have a concrete foundation wall and I able to see 3 out of the 4 surface patterns. of course some my section are in the view that the fourth surface which doesnt show the pattern.
|
This user is offline |
|
 |
|
site moderator|||

Joined: Fri, Nov 12, 2010
1749 Posts
 |
"of course some my section are in the view that the fourth surface which doesnt show the pattern."
This makes no sense. Are all of your foundation walls at the same height so your view range is cutting through them? Are they all the same type of wall? Are they all on the same phase?
|
This user is offline |
View Website
|
 |
active
Joined: Wed, Jan 27, 2010
34 Posts
 |
Yes, all of your foundation walls at the same height.the cut pattern is not in question. when I actually cut through the foundation wall the cut pattern shows up. its the surface pattern on one side of the wall that is not showing. all the VG is set correctly. the reason this causes an issue is some of the foundation walls are slightly above grade.
|
This user is offline |
|
 |
site moderator|||

Joined: Fri, Nov 12, 2010
1749 Posts
 |
Post an image of your problem. Do you have a surface pattern applied in the material?
|
This user is offline |
View Website
|
 |
active
Joined: Wed, Jan 27, 2010
34 Posts
 |
the surface material is applied to the material. I am attaching two pdf's
|
This user is offline |
|
 |
site moderator|||

Joined: Fri, Nov 12, 2010
1749 Posts
 |
Have any graphics been overridden in that view? Is there anything infront of them that would be hiding the pattern?
Edited on: Fri, Sep 13, 2013 at 9:11:27 AM
|
This user is offline |
View Website
|
 |
site moderator|||
Joined: Tue, May 16, 2006
13079 Posts
 |
Is the wall placed correctly - outside finish out? (And the wall built that way)?
|
This user is offline |
|
 |
 |