Forums >> Revit Building >> Technical Support >> trimming vertical mullions to continuous border mullion

sfountain

active

Joined: Tue, Nov 14, 2006
35 Posts
No Rating

(Revit 2014)

I'm doing a little experimentation with curtain walls, and I'm wondering if there is a way to keep the border mullions

continuous, yet still have interior mullions trim to them? for this particular situation, the border mullions have a sloping

face, so if the borders are kept continuous, then the interior mullions leave a gap between its edge and the sloping face

of the border ..I would like to be able to trim them to the border i guess...hopefuly the attached file helps clarify..

thanks!

This user is offline

WWHub

site moderator|||

Joined: Tue, May 16, 2006
13079 Posts

The only way I have seen this done is with two curtain walls.  One has everything except no vertical mullions at the grids and another CW in the same place that has empty system panels and only vertical mullions.

This user is offline

sfountain

active

Joined: Tue, Nov 14, 2006
35 Posts
No Rating

Interesting..hadnt thought of that at all...i'll give it a shot.

'preciate it!

This user is offline

sfountain

active

Joined: Tue, Nov 14, 2006
35 Posts
No Rating

here's what i get when i combine two curtain walls...a little sloppy in 3d and elevation, but looks fine in section.

thanks again

This user is offline

Creating a vertical continuous mullion with a profile edited curtainwall

0

Curtain Wall Mullion Tools

0

Curtain wall panels not trimming correctly against mullions

2

continuous vertical and horizontal custom mullion system

0

Custom Curtain wall mullions...please help!!!!

1