Forums >> Revit Building >> Technical Support >> Attach Wall base via object list?

BobbyLala

active

Joined: Tue, Aug 6, 2013
2 Posts
No Rating

Is there a way of attaching a wall to a reference line via an object list (as opposed to picking the reference plan in your view)? My problem is that I have drawn an angled reference line in one view and rotated in a perpindicular view - effectively angling my reference plane in two directions (?) But with it being rotated it isn't planar to the original view it was created in and I can't physically select it on screen to attach other walls to it.

I've attached some images to try and explain it better. I'm using Revit 2013. Open to suggestions!

Attached Images

This user is offline

WWHub

site moderator|||

Joined: Tue, May 16, 2006
13079 Posts

Create a new view that allows you to see the reference plane and the wall, then attach it.

You do know that you can rotate vertical sections?

This user is offline

BobbyLala

active

Joined: Tue, Aug 6, 2013
2 Posts
No Rating

No - didn't know you could rotate vertical sections! That worked though thanks.

So, to conclude; As long as I rotate a view that's parallel to my reference plane ( in this case my section) to the same angle I'll be able to attach my walls through that view.

Cheers!

This user is offline

How to attach top/base - walls to mass roof

6

Curtain Wall Fails to attach to Roof by Face object

2

Attach Wall up to Roof

0

Wall Base Offset... one works, one doesn't. Why?

7

Revit newbie - Tapered circular column will not attach top/base properly

1