Forums >> Revit Structure >> Technical Support >> FLOORS W/ SLOPE ARROW DO NOT GET CUT WITH VIEW RANGE?

gregroberson

active

Joined: Thu, Apr 2, 2009
140 Posts
No Rating

RST 2013

i am modelinga parking garage in RST2013.  I am preliminarily modeling the ramps as structural floors using slope arrows.  It has been working great until I try to set my view ranges.

The floors cut appropriately when they are going above the associated level.  However, for the rams going down, As soon as the depth is cut deep enough to "pick them up" in the view, the entire ramp (8'-0") deep is shown.

Can't revit cut the ramps downs as they do for the ramps up?

Greg

This user is offline

dgcad

active

Joined: Thu, Mar 17, 2005
1231 Posts

Wouldn't the View Range > 'View Depth' setting(s) solve this problem ?

-----------------------------------

FULL 'DOWNLOAD ACCESS' to all 850+ CADclips videos for only $150

This user is offline

View Website

gregroberson

active

Joined: Thu, Apr 2, 2009
140 Posts
No Rating

The view depth appears to be not working properly.  I can cut the depth just above the ramp: nothing in the view. . . cut 1" deeper, whole ramp is visible (7'-6" deep).  The view range parameters work well forthe ramps going up. .  .just not down.

This user is offline

Slope Arrow on soffit

4

REVIT 2010 - Section Cut Detail Mark & View Range

0

question using view range

0

View Range Cut Plane Associated Level is wrong

3

Floors not being cut in sections in 2013

2