Forums >> Revit Building >> Technical Support >> Wall Sweep

frankmm

active

Joined: Mon, Nov 12, 2012
32 Posts
No Rating

Hello,

I am using REVIT Architecture 2013. I am trying to place a wall sweep on a wall that has a slope. The wall sweep does not adhere to the slope. Is there a way I can make the wall sweep slope with the wall?

Thank you in advance,

Margaret

This user is offline

Typhoon

site moderator|||

Joined: Tue, May 22, 2007
5921 Posts

You have to create that with "IN-PLACE" then use the sweep tool.

-----------------------------------

I Hope and I Wish to LEARN  more, and more, and more.... REVIT

This user is offline

frankmm

active

Joined: Mon, Nov 12, 2012
32 Posts
No Rating

I was able to add the coping through "IN-PLACE" as suggested, but now it appears that there are lines extending upwards from four corners. How do I remove those lines?

This user is offline

vicozzio

active

Joined: Wed, May 14, 2008
55 Posts
No Rating

If you create it with In-Place model, to clean up the model.. I believe you have to do it in the In-Place as well.. you have to cut it using void to get clean joint..

This user is offline

Wall sweep won't trim

5

Repeatig wall sweep vs. repeating detail - wall attached [ 1 2 ]

19

How to Load a Wall sweep type

5

Hosted Wall sweep

4

Wall Sweep..... or something else... any suggestions??

3