Forums >> General Discussion >> Revit Project Management >> Mullions now showing on all plans?

EBrandon123

active

Joined: Fri, Jul 27, 2012
35 Posts

Would anyone please be able to tell me why my mullions on a standard revit storefront wall are not showing up on my ground floor plan, but are showing up fine on my first and second floor plans and also showing up fine on the 3d view. Thanks

This user is offline

WWHub

site moderator|||

Joined: Tue, May 16, 2006
13079 Posts

Are they off in the VG of that view? 

Is that CW hidden in that view?

Is that CW in a workset that is off in that view?

Is the CW in a phase that is not shown?

Is the ....?

Too little information

This user is offline

EBrandon123

active

Joined: Fri, Jul 27, 2012
35 Posts

Thank you for the reply. I had checked all of the above and was having no luck

So I have since changed the base offset of my curtain walling to 200mm (as that’s the height of my raised floor) and all the mullions suddenly appeared. I don't understand why this has happened?

Also maybe you could explain why when I set the base of the curtain walling store front to 200mm all the grid lines I deleted from the curtain walling on the ground floor to fit double doors reappeared and now all my double door have jumped back to fit in a 1500mm grid with a glazing panel beside?

This user is offline

WWHub

site moderator|||

Joined: Tue, May 16, 2006
13079 Posts

A good learning point.  Your curtain wall has pre-defined grid spacings and probaby mullions and panels.  Unless that definition is individually unlocked for each item, it will always revert to the defined spacing.  We always unlock the entire CW by changing the type to one that has no definitions what-so-ever.  Then we make or adjustments to spacing - add doors - etc,

This user is offline

door and window mullions hidden in plan views

1

Mullions not showing in plan

2

Stairs and Area Plans...

0

Adding mullions to a window

7

Window not showing mullions in 3D

5