Forums >> Revit Building >> Technical Support >> Floor drain slopes adding lines to the slope when modifying sub elements

cprepula

active

Joined: Fri, Feb 29, 2008
5 Posts
No Rating

using Revit 2013. I am trying to model the garage floor with drains and appropriate floor slopes. When modifying the sub elements to get the elevations accurate the program automatically assumes all edges of the area are at the same level. I want to show for slope lines, not lines to all corners. How can I make the floor slope based only on the outside edge of the floor?

Attached Images

This user is offline

Typhoon

site moderator|||

Joined: Tue, May 22, 2007
5921 Posts

A little confused... You can change each line / edge elevation or each point elevation, if this is what you want...

-----------------------------------

I Hope and I Wish to LEARN  more, and more, and more.... REVIT

This user is offline

cprepula

active

Joined: Fri, Feb 29, 2008
5 Posts
No Rating

The issue is that i Want to control what lines show an edge sloping towards the drain. If I specify heights of specific points and lines, it draws in mulitple lines where is believes a new slope would be. 

This user is offline

Floor slab slope to drain

4

Dual Sloped Floor without Modifying Sub Elements

4

roof issue (even roof valley slopes with uncentered drain locations)

3

Floor Drain

8

Floor Drain Primer

0