Forums
|
Forums >> Revit Building >> Technical Support >> Winder Stairs in 2013
|
|
|
active
Joined: Thu, Aug 21, 2008
100 Posts
 |
Ok so I want to create a winder stair with 2 risers going around a 90deg corner but Revit will only seemingly allow me to use the winder tool to create a 3 stair winder (and that isn't even an even spread around the corner). I can't seem to manipulate enough it without going into sketch mode. Is it possible to do this with the tools available & if so how?
|
This user is offline |
View Website
|
 | |
|
|
site moderator|||
Joined: Fri, Nov 12, 2010
1749 Posts
 |
I believe you are going to have to sketch the stair to get the results you are looking for. Your other option is once you have your stair component drawn, click on the stair and on the tools tab click CONVERT which will convert the component to a sketch and then Edit Sketch and edit your treads as needed.
Edited on: Tue, May 8, 2012 at 9:23:25 AM
|
This user is offline |
View Website
|
|
|
active
Joined: Thu, Aug 21, 2008
100 Posts
|
Using the winder tool I can get close, but just not close enough! I've done a run for the first & last sections, then deleted the landing that automatically connects the two & drawn the risers & boundary in to fit. It works but it's not an elegant solution as I get multiple up arrows!
Another tool that doesn't quite work!
|
This user is offline |
View Website
|
|
|
site moderator|||
Joined: Fri, Nov 12, 2010
1749 Posts
|
Did you try the way I suggested by converting once drawn? It should take care of your problem. Also you can shut off your UP arrows if you don't want them shown.
|
This user is offline |
View Website
|
|
|
site moderator|||
Joined: Tue, May 22, 2007
5921 Posts
|
Do it like "Teafoe5" said....
-----------------------------------
I Hope and I Wish to LEARN more, and more, and more.... REVIT |
This user is offline |
|
|
|
Similar Threads |
|
Concrete Stairs with winder |
General Discussion >> Revit Project Management
|
Fri, May 30, 2014 at 7:27:58 AM
|
1
|
|
stair with 2 winder -> railing |
Revit Building >> Technical Support
|
Wed, Sep 9, 2009 at 12:38:00 PM
|
1
|
|
Kite wind stairs |
Revit Building >> Technical Support
|
Mon, Sep 22, 2008 at 9:01:28 AM
|
1
|
|
partial wall miter below winder [ 1 2 ] |
Revit Building >> Technical Support
|
Sun, May 3, 2009 at 12:21:40 PM
|
20
|
|
FYI. Stairs showing through floors in REVIT 2013 [ 1 2 ] |
Revit Building >> Technical Support
|
Wed, Sep 23, 2015 at 2:57:56 AM
|
19
|
|
|
Site Stats
Members: | 2104979 | Objects: | 23178 | Forum Posts: | 152306 | Job Listings: | 3 |
|
Search
