Forums >> Revit Building >> Technical Support >> Stair Showing Below Mezz Slab

cboersen

active

Joined: Thu, Sep 9, 2010
105 Posts
No Rating

I have a stair going from a mezzanine down to the main level.  The opening for the stair is shorter than the stair is long (ended the opening when head height cleared).  When I look at this stair on the mezzanine plan the whole length of the stair shows even though the end entends under the mezzanine slab.  It acts as though the mezzanine slab is trasparent, but it is not.  How do I get the stair to stop displaying as it goes under the mezzanine slab?

This user is offline

teafoe5

site moderator|||

Joined: Fri, Nov 12, 2010
1749 Posts

Do you have the floor below set as your underlay?

This user is offline

View Website

cboersen

active

Joined: Thu, Sep 9, 2010
105 Posts
No Rating

Good thought, but no.  My underlay is set to "none"

This user is offline

teafoe5

site moderator|||

Joined: Fri, Nov 12, 2010
1749 Posts

Is your visual style set to wireframe? I've also seen this answer in a previous post by WWHUB....

Do you have floors?  and are they turned on?Are the floors over-ridden to transparent in view?

A quick check is just to goto the view tab, select floor plan, uncheck do not duplicate and create a new floor plan.  This will not have any mistakes in its settings.

This user is offline

View Website

cboersen

active

Joined: Thu, Sep 9, 2010
105 Posts
No Rating

The simplist of things will get you every time - it was set to wire frame.  Setting to hidden line fixed it.  Thanks for the help and the other suggestions.

This user is offline

Stair to Slab Connection

5

how to connect monolithic stair to f.c. slab

0

Showing walls from the bottom of slab

6

Creating concrete stairs from raised exterior slab

4

Slab not showing in 09

1