Forums >> Revit Building >> Technical Support >> view range

tmassey

active

Joined: Thu, May 19, 2011
167 Posts
No Rating

If I missed this or it is so stupidly easy then I apologize. 3 different floor elevation hts on this floorplan. from 0 grade to -5'

I have set my view range to 6' below 1st floor which should have picked up my corridor stair (at the top of the image) I have tried almost everything to pick this stair up on the floorplan.

Ideas?

-----------------------------------

Using Revit Architecture 2012

This user is offline

tmassey

active

Joined: Thu, May 19, 2011
167 Posts
No Rating

The structural consulant linked rvt model was hiding my stairs.

-----------------------------------

Using Revit Architecture 2012

This user is offline

view range

1

View Range

1

View Range for Revit Link

8

low wall not displaying correctly with view range

7

In place families above the view range are still appearing

6