active

Joined: Mon, May 23, 2011
124 Posts
 |
Hey guys this has been driving me nuts.. the earch hatch in my section the lines are vertical and horizontal. In Australia
we show our earth hatch on a 45ยบ angle how can I edit this to change it.
I click on my topography and hit V V to get the visibility / graphic overides up and then go down to topography
then under Projection / Surface then Patterns I go overide. Then select the earth pattern click edit but it wont let me just
rotate it in custom. If i go to simple it will but it is just single lines then.
-----------------------------------
Revit 2018........ |
active
Joined: Tue, Jan 27, 2004
80 Posts
 |
Try this:
;%VERSION=3.0
;%UNITS=INCH
*EARTH,Earth (cut)
;%TYPE=DRAFTING
;-------------------------------------------------------------------
; Pattern written by HatchKit v2.7 Hatch Pattern Editor
; HatchKit v2.7 Hatch Pattern Editor(c) Cadro Pty Ltd 1990-2008.
; www.hatchkit.com.au
;-------------------------------------------------------------------
45,-0.13258,0.13258,0.25,0.25,0.25,-0.25
45,-0.066291,0.066291,0.25,0.25,0.25,-0.25
45,0,0,0.25,0.25,0.25,-0.25
135,0,0.30936,0.25,0.25,0.25,-0.25
135,-0.066291,0.24307,0.25,0.25,0.25,-0.25
135,-0.13258,0.17678,0.25,0.25,0.25,-0.25
-----------------------------------
Hugh Adamson
www.hatchkit.com.au |