Forums >> Revit Building >> Technical Support >> Revit MEP 2012 - Linked Cad Lines being trimmed by Revit Plumbing Fixtures

Agile3100

active

Joined: Mon, Aug 9, 2010
41 Posts
No Rating

We have CAD part plans linked into our Revit Project. We completed the project in Revit 2011, we are now doing CA on it in 2012 and have found that the plumbing fixturers are trimming the CAD lines when they run accross mop sink, cabinets, ect. which are modelded in revit. We have the linked plumbing fixtures set to Ghost Surfaces, when they are set to transparent the fixtures disapear and the lines stop trimming. We need the lines to stop trimming and the fixtures to show up. I tried changing the Z plane of the lines in CAD and that did nothing. Any suggestions are appreciated, Thanks.

This user is offline

Agile3100

active

Joined: Mon, Aug 9, 2010
41 Posts
No Rating

I would like to revise one thing, the cabinets are not trimming out the lines, only the Plumbing Fixtures.

This user is offline

New to Revit MEP - need help with linked files

2

From 2D CAD MEP files to Revit MEP

1

Revit MEP 2012 View Port Error with Linked views

6

Constraining to linked CAD file

2

REVIT MEP 2012

1