Forums >> Revit Building >> Technical Support >> Scheduling sloping floors

Winston

active

Joined: Wed, Oct 25, 2006
5 Posts
No Rating

Hi

Does anyone know of a way to schedule the slope/gradient of a ramp or floor?

If I create a ramp or floor schedule, slope isn't an available parameter. And under the properties of the floor, 'slope' is greyed out and left blank even through it is a slope. If you can annotate it with a spot slope (1:10) surely you can schedule it?!

Suggestions?

Attached Images

This user is offline

WWHub

site moderator|||

Joined: Tue, May 16, 2006
13079 Posts

Instead of using a slope arrow, this slope is defined my using one edge of the floor and assigning a slope like you would on a roof.  Even when used, this field is still not available to schedule.  You could add a project parameter to floors that you could fill out and it would schedule.

This user is offline

Winston

active

Joined: Wed, Oct 25, 2006
5 Posts
No Rating

Thanks but the project paramter would be a manual entry no? If the gradient was to change I'ld have to go and manually update all of them???

This user is offline

emgeeo

active

Joined: Wed, Mar 12, 2008
322 Posts

Yes, you would have to manually update them.

This user is offline

Urgent Help ! Sloping Floors

7

Sloping floors in two directions

3

Mass Floors not all showing up - some missing

1

Joining beams to walls and floors

1

Sloped Railing

0