Forums >> Revit Systems >> Technical Support >> mullion issue

timmyd2283

active

Joined: Thu, Mar 10, 2011
14 Posts
No Rating

hello>> good morning to all >> id like to ask some question on this one>> its actually concerning a sloped glazing issue.. i tried to use the material as a trellis>> now earlier i did some research but now the issue is how can i change the mullion material, id like to change it to wood so that it will look more like a trellis rather than just a simple mullion frame. any possible solution to this>. because when i opened the type properties, the only thing i can see are the number of mullions, etc!! cant see any material where i can change it..pictures attached so at least you can visualise what the issue is> and nevermind the rendering, its in draft settings>> again thanks alot!!! :-)

Attached Images

This user is offline

WWHub

site moderator|||

Joined: Tue, May 16, 2006
13079 Posts

The mullion material is set in the mullion properties.  Find the mullion type in your browser and change the material there.

Attached Images

This user is offline

timmyd2283

active

Joined: Thu, Mar 10, 2011
14 Posts
No Rating

hmmm>> thanks a bunch>> didnt figure that out earlier>> again thanks!!! :-)

This user is offline

mullion ang transom not fitting well [ 1 2 ]

23

Curtain Mullion eats into vert mullion

4

mullion join at angled mullion 2017

1

Curtainwall door mullion/jamb issue - door is wider than inside mullion spacing

1

coneptual massing curtainwall mullion issue

1