Forums >> Revit Building >> Technical Support >> Door family elements showing in plans

A5Len

active

Joined: Thu, Jun 8, 2006
35 Posts
No Rating

I have created a sectional overhead door family. When I place it in my project plans the rails above the door head show in plan. There are 3 rails - the 2 side rails which are sweeps that run up the door jamb and then continue along the ceiling do not show correctly in plan ie part of rail below cut plane shows & the rest doesn't. However the central rail that only runs along the ceiling shows up on the plan. This rail is associated to a plane above the door head and does not protrude through the cut plane in the family or project. It is also not joined to any other elements.

I have previously had this issue with a roller door I created where the drum was always vissible in plan.

I tried playing with vissability settings however making it not vissible in plan also means it is not visible in RCP, so that doesn't help.

I have made plenty of custom doors in the past and have not had this issue

Anyone got any ideas?

Thanks

This user is offline

Door Swings in reflected ceiling plans

2

Door family showing one thing in Family Editor another when placed into project.

3

Low elements in a casework family showing up in RCP (Revit Architecture 2012)

3

linewidth of elements in family editing

2

Mullions now showing on all plans?

3