Forums >> Revit Building >> Technical Support >> Scheduling Coordinate Points for Complex Geometry

kcdyer13

active

Joined: Thu, Jul 19, 2007
2 Posts
No Rating

Hello All,

 I am trying to efficiently document complex exterior wall geometry.  I was hoping to use spot coordinates that could show the X,Y,Z components from a set 0,0.  Then, be able to set up the X,Y,Z components in a schedule which will have to be exported to Excel.  Any suggestions?  Has anyone used the Excitech tool for Revit 2011?  Any help would be greatly appreciated!

This user is offline

WWHub

site moderator|||

Joined: Tue, May 16, 2006
13079 Posts

Check out the extensions availble with your subscription .  I thik this is the one you are looking for:

http://www.extensions4revit.com/n/e4r/856/60 

This user is offline

kcdyer13

active

Joined: Thu, Jul 19, 2007
2 Posts
No Rating

Thanks, WWHub!

I am looking for something that would read the coordinates without manual input, do you know if this might do that?  I will research this extension a little further, too.

Thanks again...

This user is offline

Creating Complex geometry

1

Scheduling Topographic points

0

Families - Locking complex geometry

3

Mass Geometry Flaw | Circle points

1

Allow 3 point Definition for Reference Planes

0