Forums >> Revit Building >> Technical Support >> Cutting through a sweep

cma6490

active

Joined: Thu, Jul 8, 2010
1 Posts
No Rating

I designed a log cabin in revit. For the walls i used sweeps to make it look like logs in 3d view. When i went to 3d view it wont cut the sweeps to show the trim. it only cuts out to show the windows. I tried to design a component in place and make a void extrusion and cut it but it doesnt seem to cut the sweeps. If anyone could help that would be great.

Thanks

This user is offline

WWHub

site moderator|||

Joined: Tue, May 16, 2006
13079 Posts

Not clear :> "...When i went to 3d view it wont cut the sweeps to show the trim. it only cuts out to show the windows."

Sweeps added to walls only square cut at the wall ends so I don't like sweeps or reveals for these.  Check out this thread and see if this helps: http://www.revitcity.com/forums.php?action=viewthread&thread_id=17944 

Otherwise, read some of the many posts ikn the forums searching with only the word -  log.

This user is offline

cutting through a sweep

1

Cutting a Sweep - Brick Detail

0

Solid Sweep Not Cutting in Section

2

Vertical Wall Reveals not cutting sweep

0

Cutting Solid Sweep?

0