Forums >> Revit Building >> Technical Support >> Callouts are funny

echo1

active

Joined: Thu, Jun 26, 2008
14 Posts
No Rating

I have been stumped for a while and was unable to find anything searching the old forum threads...  I have in front of me now an elevation that should have two building section callouts in it.  Only one shows.  I checked the VG and for hidden objects.  It does the same thing on the opposite elevation where the same two should building section callouts should show.  A cross directional section does show both building sections in question.  I tried adjusting the extent of the section to make sure it crosses the elevation plane.

But in another post to a similar problem:  

 So I tried this and the both sections show up when I change the scale to anything larger or smaller than 3/16" = 1'...  I have been using Revit a good while but I am not sure what WWHub is referring two with hiding (or not) callouts by scale.  I am using old fashioned 2010 Revit Architecture.  All sections and elevations are at 3/16" scale.

Thanks!! 

This user is offline

echo1

active

Joined: Thu, Jun 26, 2008
14 Posts
No Rating

Still stumbling.

 I tried recreating the problem in a new file but without success.  

I place a new section in the area... but it has the same issue. 

I change the callout to a wall section, still dissapears when it goes to 3/16" or 1/8" or smaller.

This user is offline

echo1

active

Joined: Thu, Jun 26, 2008
14 Posts
No Rating

SO NOW I find the hide at scales courser than option....  I scanned the section cut properties several times before and missed this.  Apparently building section automatically set this to the scale they are created in.

 I am not sure how this basic function has eluded me.. but now I know and knowing is half the battle. 

This user is offline

Are Callouts Vew Specific?

9

HELP! callouts are not visible!!

5

Callouts and Callout Sim Views

1

multiple section callouts

1

Visibility of callouts

0