Forums >> Revit Building >> Technical Support >> Reference Planes along curve in 3D RAC 2009

Jmarchese

active

Joined: Tue, Mar 4, 2008
38 Posts
No Rating

I'm trying to manually place a curtain wall grid on a curved curtain wall.  The grid spacing needs to be at 2, 3, and 5' increments.  What I planned on doing was arraying reference planes along a curve and manually placing a grid line where it intersected the curtain wall, however I cannot see the reference planes in 3d.  I'm assuming this is because theu are not parallel to the elevation view.  Do you guys have any other suggestions as to how I can create this curved curtain wall?

 Thanks,

Jim

This user is offline

tim123

active

Joined: Tue, Apr 12, 2005
1310 Posts

This user is offline

View Website

dgcad

active

Joined: Thu, Mar 17, 2005
1231 Posts

-----------------------------------

FULL 'DOWNLOAD ACCESS' to all 850+ CADclips videos for only $150

This user is offline

View Website

Jmarchese

active

Joined: Tue, Mar 4, 2008
38 Posts
No Rating

I'm not sure what you mean by "Do it in a plan view".

 The problem I have with reference lines is that I need to draw them in plan but I also need to see where they land in elevation.  I'll give it a shot though.

Thanks for your replies!

This user is offline

Locking Detail Curve to Reference Plane for Paramterizing (RAC 2012)

1

Listing the Abilities of Reference Planes

2

reference planes

0

Detail Lines and Reference Planes

3

reference planes

2