Forums >> Community >> The Studio >> Flush Gable End

phillip101

active

Joined: Thu, Jul 3, 2008
4 Posts
No Rating

hi all,

i'm a new user of revit and getting on great with it, but have run into a problem, in autocad architecture i was able to create a flush gable end easly by abstracting  a mass from the roof and alining the walls to the roof. can this be done in revit & how this could be achieved. i have a photo to what i mean many thanks and a great web site.

phillip

using revit architecture 2009

Attached Images

This user is offline

Typhoon

site moderator|||

Joined: Tue, May 22, 2007
5921 Posts

Hi, if i understand what do you want it's very simple, see the video: http://screencast.com/t/s3sEkPfSqdZ

-----------------------------------

I Hope and I Wish to LEARN  more, and more, and more.... REVIT

This user is offline

phillip101

active

Joined: Thu, Jul 3, 2008
4 Posts
No Rating

hi typhoon

thanks for the fast reply. for reasons unknown i can view the video, i've unistalled flash but no good, is possible you could email it on to me

 many thanks

phillip

This user is offline

phillip101

active

Joined: Thu, Jul 3, 2008
4 Posts
No Rating

hi again

got video to work, if you look at picture in first post, you will see how the walls and the slate roof meet at the gable, no facia visible,

This user is offline

Typhoon

site moderator|||

Joined: Tue, May 22, 2007
5921 Posts

Hy again, see the video and give me a feedback: http://screencast.com/t/eGScTDDj1M

Send me a feedback...

-----------------------------------

I Hope and I Wish to LEARN  more, and more, and more.... REVIT

This user is offline

phillip101

active

Joined: Thu, Jul 3, 2008
4 Posts
No Rating

hi typhoon

thanks again for fast reply, i think i solved it check out gable 1 & 2, i sketched the wall to below slate roof, and hide bottom line.

Attached Images

This user is offline

Gable End Fascia

3

Stair - end riser flush with stringer

1

Gable End Wall

1

small hip

0

gable end walls with outlookers

0