Forums >> Revit Building >> Technical Support >> weird roof edge

dfitzladdy

active

Joined: Tue, May 27, 2008
49 Posts

Hallo!  I'm having serious issues with some of my roof edges.  I created this generic 9" roof by footprint, and once it was created i switched the rafter cut from plumb cut to two cut square.  when i did this, I noticed that one of the edges hovers above the work plane about an inch high, and for about a foot deep.  See attached image...  I only have this problem with this type of hip roof, and only where the hip of the roof touches the work plane.  I'm so confused!!!

thanks!

Dfitzladdy -- using Revit 2008.

Attached Images

This user is offline

dfitzladdy

active

Joined: Tue, May 27, 2008
49 Posts

i just noticed that the depth of the void is actually 9", not 12", so it is the thickness of the roof, if that helps understand the problem...

This user is offline

Roof Edge Color

0

bottom edge of roof line weight

3

Sloped Roof Edge

2

Roof w/ bevealed edge

1

Roof edge rendering

0