|
active
Joined: Mon, May 12, 2008
4 Posts
No Rating |
I've got a few mysteries... When I plot my sheets, some of the sheets show line breaks where wires cross. Most don't. It's not circuit specific, it's sheet specific. It's either all or none on the sheet. Also, no line breaks at all are shown in the floor plan view or sheet view. They only show up in plotting. And, I don't remember this being and issue in 2008, but the wires don't even make contact with the fixtures or devices. They stop a couple feet short. Anyone??? Anyone??? I understand that this is a modelling program, but what ultimately goes out is still a set of 2D drawings. It makes me as a draftsman cringe when I see the horrible drafting abilities of Revit. It's great software in theory and I'm sure that one day it will become a standard, but Revit MEP is just not ready for use right now. At least not electrically. Try explaining that to an architect, though!
|
Search