Forums >> Revit Building >> Technical Support >> mullion shape

dfitzladd

active

Joined: Tue, Nov 7, 2006
4 Posts
No Rating

   I'm trying to change the shape of a corner mullion into essentially the shape of an arrow... sort of an L corner mullion that is 1' thick with 3/4" legs on either side.  So far I have had success in placing a 1.5" x 12" mullion at 45 degrees on the end of the curtain wall, but it is not exactly what I need.  The short end on the outside needs to point out, the short end on the inside needs to point in...... like an arrow.  help!!!!

This user is offline

mullion ang transom not fitting well [ 1 2 ]

23

Adding New Mullions to your Mullion Tab Options

6

curtain wall mullion tapering with mass - Revit 2013

5

Curtain Mullion eats into vert mullion

4

mullion arc shape

3